![]() ![]() ![]() To set the video bitrate of the output file to 64kbit/s:.All options apply ONLY to the next input or output file and are reset between files. Also do not mix options which belong to different files. verbosity level), which should be specified first.ĭo not mix input and output files – first specify all input files, then all output files. Exceptions from this rule are the global options (e.g. Each occurrence is then applied to the next input or output file. Therefore, order is important, and you can have the same option on the command line multiple times. See also the Stream specifiers chapter.Īs a general rule, options are applied to the next specified file. E.g. 2:3 refers to the fourth stream in the third input file. Similarly, streams within a file are referred to by their indices. ![]() the first input file is 0, the second is 1 etc. To refer to input files in options, you must use their indices (0-based). Selecting, which streams from which inputs go into output, is done either automatically or with the -map option (see the Stream selection chapter). Allowed number and/or types of streams can be limited by the container format. Anything found on the command line which cannot be interpreted as an option is considered to be an output filename.Įach input or output file can in principle contain any number of streams of different types (video/audio/subtitle/attachment/data). It can also convert between arbitrary sample rates and resize video on the fly with a high quality polyphase filter.įfmpeg reads from an arbitrary number of input "files" (which can be regular files, pipes, network streams, grabbing devices, etc.), specified by the -i option, and writes to an arbitrary number of output "files", which are specified by a plain output filename.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |